Free LightBurn 1.4.013/31/2024 ![]() If anyone has any suggestions, I’d love to hear them. I replaced the USB cable as well as the PC port. ![]() Nothing has changed with the PC recently, other than the software version. I have a job to do today and it’s very frustrating crashing very often, every 3 or 4 runs. I have shut down the PC several times since then. I don’t believe it’s a sleep/inactivity issue, but cause my PC is set to always on. I went though some of the other posts about usb disconnects. I updated to 1.4.01 first thing this morning I checked and I was on the latest version. Then I turn it on, windows chimes to let me know a USB has been connected and it often starts working then. When I turn it off the windows chimes to let me know a USB has disconnected. When it disconnects about 1/2 the time Lightburn comes up and says “lightburn has crashed” and the other times I can just turn off my fiber laser and turn it back on. When it comes up disconnected in lightburn, it isn’t disconnected in the hardware management. Eventually I realized the laser was disconnecting. Put in my license and it was working fine.Ībout an hour later… it started acting up… For example I would close the framing window and it will stay framing. When it opened, I realized my year license was over, so I purchased another year. So I updated, when I installed I screwed up and reinstalled the galvo drivers. Then I got a message about a new version 1.4. Maybe a lockup / crash once a month, not every day! I switched to lightburn a year ago and the first year was great. Used EZCad for year before Lightburn, and ezcad would crash or mess up every day.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |